Use this DFRduino Ethernet W5100S Shield to connect your Arduino to the Internet with a RJ45 cable. Plug the shield onto the board, burn the Ethernet sample codes into the controller, then an easy IoT project with stable communication is done. Based on WizNet WS5100S Ethernet chip, this board integrates full hardwired TCP/IP protocol stacks and has 4 independent hardware SOCKETs. Your Arduino board can communicate with WS5100S and SD card through the SPI interface(use ICSP pin). The DFRduino Ethernet W5100S expansion board supports both Arduino UNO and Mega series.
Current hardware version V3.0: the chip has been upgraded from W5100 to W5100S, which comes with lower power consumption, lower heat and higher performance.
Features
Full hardwired TCP/IP protocol stacks
Support 4 independent hardware SOCKETs simultaneously
Disclaimer: MLAB is not affiliated, associated, authorized, endorsed by, or in any way officially connected with Arduino AG, Raspberry Pi Trading Ltd., Espressif Systems (Shanghai) Co., Ltd., or any of their subsidiaries or affiliates. All product names, trademarks, and registered trademarks are the property of their respective owners. Our boards and products are designed to be compatible with these platforms and are intended for educational, prototyping, and development purposes. The use of these trademarks is for descriptive and referential purposes only and does not imply any endorsement or sponsorship.
Choosing a selection results in a full page refresh.
